Department of Naval Architecture and Ocean Engineering, Division of Global Architecture, Graduate School of Engineering, Osaka University

Thesis

2021

Master

Iihara RyousukeCollapse analysis of asymmetrically damaged ship hull girder using hydro-elastoplastic beam model
Ono TomokiSurrogate Model for Vertical Bending Moments Predicted by Using Coupled CFD-FEM and its Application to Extreme Value Prediction
Saito TakaakiA proposal of pseudo-sensor using Neural Network and its application to fatigue damage assessment
Sonoda GodaiPrediction of hull structural reliability integrating strain monitoring and wave forecasting data
Hara KentarouSoftware-in-loop Using Ducted Fan and Optical Tracking for Hybrid Test of Floating Wind Turbine

2020

Doctor

佐野 敦司 (Sano Atsushi)液化ガス運搬船向け非真球タンクの部分積み時の座屈強度に関する研究
白石 哲平 (Shiraishi Teppei) 全船荷重・構造一貫解析による単船側バルクキャリアの荷重および最終強度評価
Han Htoo Htoo KoCollapse Analysis of Ship Hull Girder Using Hydro-Elastoplastic Beam Model

Master

Utsunomiya IppeiReal-time estimation of structural state of an inclined ship from a limited number of sensors by using Kalman filter
Shimiya TomohiroDevelopment of a hydro-elastoplastic beam model for predicting dynamic collapse response of ship hull girder in wave
Inoue TomoyaDevelopment of Aerodynamic Load Model in Predicting Structural Behavior of FOWT under Combined Wind and Waves
Kimura YukiStress response and critical strength of side panel structure of bulk carrier subjected to external pressure
Isnaini RodhiatulStill water bending moment evaluation on beam through cargo loading prediction using Kalman filter

2019

Master

Koichiro KinugawaDevelopment of Estimation System for Global Deformation of Ship Structure by Using Sensors and Numerical Model
Katsuki KosaiCombined local/global buckling analysis of stiffened panel considering plate/stiffener interaction
Tomohiro FujimotoCumulative buckling behavior of stiffened panel under repeated compressive loads

2018

Doctor

Tomoki TakamiDevelopment of Coupled CFD-FEA Analysis Method for Structural Load of Ships and its Application to Extreme Value Prediction by FORM

Master

Rikako AramakiStructural reliability analysis of hull-girder collapse of container ship considering the effects of bottom local loads
Raito KabashimaStochastic approach for evaluation of fatigue damage of FOWT subject to combined wind and wave loads
Syuta TatsukawaCollapse analysis of ship hull girder using hydro-elastoplastic beam model
Kenji NakanoFundamental study on collapse response analysis of ship hull girder in waves
Hirohito NishidaEfficient load estimation for structural health monitoring of a large ship based on small nnumber of sensors
Masahumi YamamotoAnalytical and experimental investigations into second order nonlinear waves along VLFS

2017

Master

Takuya IzakiUltimate Longitudinal Bending Strength of Container Ship Considering Bottom Local Loads
Rika UedaEffect of Weather Routing on Maximum Vertical Bending Moment in Container Ship by Direct Numerical Simulations
Yuki KadokamiExperimental Investigation into Collapse Behavior of Ship's Hull Girder under Whipping Load
Kento GodaApplication of Coupled SPH/FEM Analysis to Problems in Marine Structures
Satoshi TakagiFatigue Strength Assessment of Drill String in Deep-Sea Riser Drilling
Koji MorishitaCumulative Buckling Behavior of Stiffened Panel under Cyclic Loads

2016

Doctor

Akira TatsumiUltimate Logitudinal Bending Strength of Container Ships Considering Bottom Local Loads

Master

Taisuke OzakiNumerical and experimental investigation of aquacultural net deformation inuniform current
Megumi SakaiCollapse behavior of VLFS under extreme wave load by segmented beam approach
Ryota SakamotoWave load causing extreme response on flexible jacket foundation
Taiken TokuharaAnalysis and experiment of kink behavior of helical cables
Naohito MuroBuckling/plastic collapse behavior of a stiffened panel under cyclic compression
Yahui XingNumerical simulation of motion and deformation of VLFS during joining process

2015

Doctor

Noboru Kiji強度ミスマッチを有する大入熱溶接継手の破壊じん性評価手法に関する研究
Yoshiteru Tanaka複合荷重を受ける船体梁の実用的最終強度評価法に関する研究

Master

Yuiko KurodaDesign Parameters Governing Weathervane Performance of Single-Point-Moored FOWTs
Ryuichi TakagiCurrent-induced Deformation of Aquaculture Net Interacting with Circular PE Pipe
Kouhei HokaiFatigue Strength Assessment of Drill Pipe in Ocean Drilling
Itsuro HiraiAnalysis of Kink Phenomenon of a Cable Composed of Helical Wires and Strands
Kazuki MurataFundamental Study on Combined Motion and Collapse Analysis of Ship Hull Girder Using Smith’s Method
Yusuke MurataTripping Strength of Ring Frame in Stiffened Cylinder under External Pressure

2014

Master

Yuichiro OhtaBuckling/Plastic Collapse Behavior of Stiffened Panel under Cyclic Loads
Kento NakamuraDesign Irregular Waves by FORM for Predicting an Extreme Motion of a Floating Body Subjected to Slowly Varying Drift Force and Nonlinear Mooring Force
Tomoaki MiyataFE Modeling for Buckling Collapse Analysis of a Continuous Stiffened Panel under Combined Loads
Including In-plane Shear
Kohei YamakawaUltimate Longitudinal Hull Girder Strength Considering Local Load Effects

2013

Master

Syogo UdaBuckling/Plastic Collapse Analysis of a Continuous Stiffened Panel under Combined Loads using Periodic Boundary Condition
Misako KawaiDiscussion on Partial Safety Factors for Floating Structures supporting Wind Turbine
Makoto GotoCollapse Analysis of Ship Hull Girder in Waves Considering Fluid-structure Interaction
Tomoyo KozakaFatigue Loadings for Rotating Shaft and Blades of Floating Offshore Wind Turbine based on Decoupled Analysis
Yuko SuzakiPost-ultimate Strength Behavior of Ship’s Hull Girder under Whipping Loads
Sadaoki MatsuiEstimate of Ultimate Strength of Ring-Stiffened Cylinder under Axial Compression Considering Initial Imperfection and Multi-span Effect

 

Please feel free to contact us. TEL +81-6-6879-7585

PAGETOP
Copyright © Structural Integrity Subarea All Rights Reserved.
Powered by WordPress & BizVektor Theme by Vektor,Inc. technology.